WorldCat Identities

Healzer, J. M.

Overview
Works: 11 works in 13 publications in 1 language and 32 library holdings
Classifications: TA357.5, 333.82
Publication Timeline
.
Most widely held works by J. M Healzer
Prediction of annular liquid-gas flow with entrainment : concurrent vertical pipe flow with gravity( Book )

2 editions published in 1980 in English and held by 10 WorldCat member libraries worldwide

Prediction of critical heat flux for annular flow in vertical pipes( Book )

1 edition published in 1980 in English and held by 5 WorldCat member libraries worldwide

NATBWR, a steady-state model for natural circulation in boiling water reactors( Book )

1 edition published in 1983 in English and held by 4 WorldCat member libraries worldwide

Two-phase jet modeling and data comparison( Book )

2 editions published in 1986 in English and held by 3 WorldCat member libraries worldwide

Data on four PWR plant transients( Book )

1 edition published in 1984 in English and held by 2 WorldCat member libraries worldwide

The multivent hydrodynamic model for calculating pool boundary loads due to chugging Mark I containments by S. A Wilson( Book )

1 edition published in 1978 in English and held by 1 WorldCat member library worldwide

Marviken critical flow data parametric trends and comparison with selected critical flow models by D Abdollahian( Book )

1 edition published in 1980 in English and held by 1 WorldCat member library worldwide

Single vent chugging model( Book )

1 edition published in 1977 in English and held by 1 WorldCat member library worldwide

Critical flow data review and analysis : part 4 modeling recommendations by D Abdollahian( Book )

1 edition published in 1980 in English and held by 1 WorldCat member library worldwide

Mark I Task 5.17 : medium mass flux condensation oscillations : Phase I summary report by W. J Bilanin( Book )

1 edition published in 1977 in English and held by 1 WorldCat member library worldwide

The turbulent boundary layer on a porous plate: experimental heat transfer with uniform blowing and suction by R. J Moffat( )

1 edition published in 1974 in English and held by 0 WorldCat member libraries worldwide

Stanton number measurements have been made for a transpired turbulent boundary layer on a rough surface. Tests were conducted at uniform blowing fractions from 0 to .008, with uniform surface temperature and uniform free- stream velocity. The x-reynolds number range of these tests was from 100,000 to 10 to the 7th power and the roughness Reynolds number range from 20 to 200. The data are believed to be accurate to within + or - 0001 Stanton number units over most of this range. At each test condition, several velocity profiles were taken to measure the boundary layer growth. The boundary layer momentum thickness variation along the test surface has been used to estimate rough-plate skin friction. The data indicate the expected increase in both skin friction and heat transfer due to roughness. The data display some unusual features when plotted against boundary layer size
 
moreShow More Titles
fewerShow Fewer Titles
Audience Level
0
Audience Level
1
  Kids General Special  
Audience level: 0.72 (from 0.69 for Prediction ... to 0.83 for The turbul ...)

Languages
English (13)